START
•
Turn on at wall.
•
Prewash Zone:
Fit Wash Pump Filter (3)
Fit Drain Upstand(2).
Fit Scrap Tray (1).
•
Wash Zone:
Fit Wash Pump Filter (12).
Fit Drain Upstand (11) .
Fit Scrap Trays (10).
•
Rinse Zone:
Fit Rinse Pump Filter (20).
Fit Drain Plug (19).
Fit Scrap Tray (18).
•
Shut all doors and turn wall and Machine Power on.
•
Machine begins filling. Full light glows amber when tanks are full.
•
Ready light glows amber when the machine is up to required temperature.
OPERATION
•
Press Start button to operate machine.
•
Cycle light glows green while machine operates.
•
Stack one rack with items. Push the rack fully into the inlet zone of the machine. Ensure
the rack is pushed fully into the inlet to engage pawl drive.
•
Repeat for all consecutive racks
NOTE: Pumps and conveyor will stop operating if the machine is left idle for 2 minutes. To
restart the pump and conveyor simply feed a new rack into the inlet of the machine.
SHUT DOWN
–
END OF EACH DAY
•
Press Stop button.
•
Switch Power button off.
•
Take out Drain Upstands and Drain Plug to gravity drain the machine.
•
Proceed with Operator Care cleaning instructions.
SUGGESTED BEST PRACTICE
Pre-rinse
Scrape and/or rinse trays, plates & glasses in cool water
Chemical
Use a good quality non foaming commercial detergent and drying agent
–
do
not use domestic detergents which will cause the wash tank to foam
12/5/2022
Washtech CD240L Operator Manual
10
Operator Use Guide