Installation manual
29
7.
Disconnect ignitor wires from harness and then take out the gas valve.
8.
Remove the burner injector from the valve and replace it with the injector inside the accessory bag. Torque the
new injector to 30 in-lbs (3.4 N·m).
Use the injector (diameter 1.21mm) for both Butane gas and Propane gas
9.
Grab the dimples (not the cap) with the lips of needle nosed pliers to twist the cover until the marking LPG point
toward the base point.
10. Apply STICKER A (LP Gas Valve Sticker) over the existing valve label.
11. Put the gas valve back on the burner assembly. Securely tighten the two mounting screws. Reconnect the valve
to the harness.
12. Check all connections to ensure no leakage with referring to the method of leak check as the next page.
13. Connect a manometer to measure the injector pressure, its details of the pressure test as below.
E
F
fig.W01628
G
fig.W01629
E
Apply STICKER A Here
F
the New Injector
G
Base Point