background image

3

Grounding type
wall receptacle

Power supply

cord with 3-prong

grounding plug

Do not under
any circumstances
cut, remove,
or bypass
the grounding prong
from this plug.

 

Do not use or

mix liquid chlorine bleach
with other household
chemicals such as toilet
cleaners, rust removers,
acid or products containing
ammonia. These mixtures
can produce dangerous
fumes which can cause
serious injury or death.

 

Avoid fire

hazard or electrical shock.
Do not use an adaptor plug
or extension cord or remove
grounding prong from
electrical power cord.
Failure to follow this
warning can cause serious
injury, fire or death.

FOR YOUR SAFETY

Do not store or use gasoline
or other flammable vapors
or liquids in the vicinity of
this or any other appliance.

Your washer is equipped with a door safety interlock. Verify proper operation of interlock system daily, using the following procedure:

1. With the washer door open, insert the required number of coins (or the appropriate card, on machines equipped

with a card-start system) and press the START button. THE WASHER MUST NOT START!

2. Close the washer door. Press the START button again to start the machine. Attempt to open the door, without  exerting excessive force.

THE DOOR MUST NOT OPEN!

IF THE WASHER STARTS WITH THE DOOR OPEN, OR THE DOOR CAN BE OPENED WHILE THE WASHER IS OPERATING, THE MACHINE
MUST IMMEDIATELY BE TAKEN OUT OF SERVICE. DISCONNECT THE POWER CORD, AND MARK THE MACHINE "OUT OF ORDER", UNTIL
THE INTERLOCK SYSTEM IS REPAIRED, AND OPERATES AS DESCRIBED ABOVE.

If you have questions regarding operation of this machine, or proper testing of the door interlock system, 

contact

Wascomat Service at 1-516-371-0700.

Read all instructions before using this washer.

Important Safety Instructions

CORRECT

Use this way ONLY

Note:

 The instructions

appearing in this INSTALLATION
AND SAFETY INSTRUCTIONS
manual are not meant to cover
every possible condition and
situation that may occur.
Common sense and caution
must be practiced when
installing, operating and
maintaining any appliance.

 

You can be killed or seriously injured if you don't follow these Important Safety Instructions:

•To reduce the risk of fire, electrical shock, or injury to persons when using this washer, comply with the basic
warnings listed below.
• Failure to comply with these warnings could result in serious personal injuries.

Prevent Fire

•  Do not wash items that have been previously cleaned in, soaked in, or spotted with gasoline, cleaning solvents,
kerosene, cooking oils, waxes, etc. Do not store these items on or near the washer. These substances give off vapors
or chemical reactions that could ignite or explode.
•  Do not put oily or greasy rags or clothing on top of the washer.  These substances give off vapors that could
ignite the materials.
•  Do not add gasoline, cleaning solvents, or other flammable or explosive substances to the wash water.  These
substances give off vapors that could ignite or explode.
• Under certain conditions, hydrogen gas may be produced in a hot water system that has not been used for 2
weeks or more.  

HYDROGEN GAS IS EXPLOSIVE.

  If the hot water system has not been used for such a period,

before using the washer, turn on all hot water faucets and let the water flow from each for several minutes.  This
will release any accumulated hydrogen gas. Hydrogen gas is flammable; do not smoke or use an open flame during
this time.
• Failure to comply with these warnings could result in fire, explosion, serious bodily injury and/or damage to the
rubber or plastic parts of the washer.

Protect Children

• Do not allow children to play on or in the washer. Close supervision of children is necessary when the washer
is used near children. As children grow, teach them the proper, safe use of all appliances.
•Destroy the carton, plastic bag and other packing materials after the washer is unpacked. Children might use
them for play. Cartons covered with rugs, bedspreads or plastic sheets can become airtight chambers.
• Keep laundry products out of children's reach. To prevent personal injury, observe all warnings on product labels.
• Before the washer is removed from service or discarded, remove the washer lid to prevent accidental entrapment.
• Failure to comply with these warnings could result in serious personal injuries.

Prevent Injury

• Test door interlock system daily. Follow instructions on previous page.
• To prevent shock hazard and assure stability during operation, the washer must be installed and electrically
grounded by a qualified service person in accordance with local codes.  Refer to INSTALLATION AND SAFETY
INSTRUCTIONS for detailed grounding procedures. If the washer is moved to a new location, have it checked and
reinstalled by a qualified service person.
• To prevent personal injury or damage to the washer, the electrical power cord of the washer must be plugged
into a properly grounded and polarized 3-prong outlet. 

The third grounding prong must never be removed.

Never ground the washer to a gas pipe. Do not use an extension cord or an adaptor plug.

• Follow package directions when using laundry products.  Incorrect usage can produce poisonous gas--resulting
in serious injury or death.

-

Do not  

combine laundry products for use in 1 load unless specified on the label.

-

Do not

 mix chlorine bleach with ammonia or acids such as vinegar.

• To prevent serious personal injury and damage to the washer:

-

All repairs and servicing must be performed by an authorized servicer 

unless specifically recommended

in this INSTALLATION AND SAFETY INSTRUCTIONS manual. Use only authorized factory parts.

-

Do not

 tamper with controls.

-

Do not  

install or store the washer where it will be exposed to the weather.

 

To reduce the risk of electric shock, disconnect this appliance from the power supply before attempting any user

maintenance. Turning the controls to the OFF position does not disconnect this appliance from the power supply.
• To prevent injury, do not reach into the washer while parts are moving.  Before loading, unloading or adding
items, push in the cycle selector knob and allow the tub to coast to a complete stop before reaching inside.
• Failure to comply with these warnings could result in serious personal injuries.
• This washer is equipped with an electrical overload protector. The motor will stop if it becomes overheated. The
washer will automatically restart after a cool down period of up to 30 minutes, if the washer has not been manually
turned off during this time.

SAVE THESE INSTRUCTIONS

3

Summary of Contents for Full Size Tumble Action Washer












Reviews: