Installation
WARNING
• Never test for leaks with a flame!!!
WARNING
• This appliance must only be operated with the gas type indicated on the dryer’s data
plate. If the appliance is converted (gas type changed), a data plate amendment must
be obtained from the manufacturer (dryer’s serial number is required to purchase a
conversion kit).
IMPORTANT
• Any burner changes or conversions must be made by qualified personnel.
CONVERSION FROM NATURAL GAS TO PROPANE GAS
WARNING
This procedure must be carried out by a qualified, licensed gas-appliance technician.
• Disconnect electrical power to the dryer.
• Close all shut-off valves in the dryer’s gas supply line.
• Open the toe panel of the dryer.
• Disconnect ignitor wires from harness and
then remove the burner tube.
• Remove the burner orifice from the valve
and replace it with the proper orifice. Use
orifice # 44 for NG and orifice # 55 for LP.
Orifice number is stamped on the edge of
the hex head of the orifice. Securely tighten.
• Put the burner tube on the burner assembly.
Securely tighten.
• Reconnect the ignitor to the harness.
• Observe the cover dial settings indicated
as NG and LP along with the gas type
indicator.
• Position a pair of needle nose pliers into the
slots of the cover dial.
• Rotate the cover dial to line up with LP
marking with the indicator on the gas valve.
WARNING
• Improper FUEL Conversions can result in fire or explosion!
2:10
