Proper handing of the gun is essential for obtaining a good finish. The gun should be held at a right angle to
the surface being covered, and moved parallel with it. For precise control of the gun and material, the trigger should be
released before the end of the stroke.
Hold the gun from 6 to 12 inches away from the surface depending on material and atomizing pressure. For
a uniform finish, lap each stroke over the preceding stroke, making sure the spray is smooth and wet. Using the lowest
possible atomizing air pressure will reduce overspray and provide maximum efficiency.
Cleaning & Maintenance
Prior to cleaning, make sure to disconnect the spray gun from the air compressor system.
Empty the cup, using WRENCH to remove the cup from the spray gun. NEVER USE HAND.
Always use proper tool to assemble and disassemble the parts. DO NOT remove the brass baffle.
Use proper cleaning solution. DO NOT use acid or any other aggressive chemical as they may result in parts failure.
Submerge the front end of the gun in solvent just to cover the fluid connection. Paint built up on the gun should be
removed by using tools [ACC-818] cleaning kit.
Never submerge the entire spray gun in solvent :
-
This will dissolve the lubricant in the leather packing and on wear surfaces, causing them to dry out and resulting
in difficult operation and faster wear.
-
Air path in the gun will clog with dirty solvent.
Using a rag moistened with solvent, wipe down the outside of the gun.
Oil gun daily. Use a drop of lightweight machine oil on Fluid needle, Air valve packing, and Trigger pivot point.
NOTE: DO NOT use lubricants which contain silicone. Silicone may cause defects in the finish application.
Submerge the front end of the gun in solvent just to cover the fluid connection. Paint built up on the gun should be
removed by using tools [ACC-818] cleaning kit.
To clean nozzle, immerse it in solvent until dried material is dissolved, and blow it clean afterwards.
DO NOT
use metal
or sharp instrument to probe any of the holes in the nozzle.
Service, Warranty and Liability
Warwick Industries Inc. CANNOT be held responsible in the following cases:
-
When proper operating instruction is disregarded.
-
When spray gun is manipulated, altered, inappropriate assemble/disassemble or use with non-warwick original
parts on the spray guns.
Warranty detail information is listed on our website. For service, you should reach your local distributor for further
assistance. If your distributor is not able to help, please contact us at
Great Quality Best Value Unbeatable Service – Warwick industries Inc. since 1995
Page 2
