Page 9
For technical questions, please call 1-888-866-5797.
Item 58389
Sa
Fety
Opera
ti
O
n
Maintenance
Setup
Workpiece and Work area Set up
1. Designate a work area that is clean and well lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
3. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
General instructions for use
1. Make sure the Direction Switch is in the center
position, locking the trigger off. Then, insert the
Battery Pack making sure it clicks into place
securely. To remove Battery Pack, press the
Battery Button to release it from the Drill.
cautiOn!
Most drill bits are designed for use in
the forward, clockwise direction. Do not use a drill
bit in the opposite direction than it is designed for.
2. Slide the Direction Switch to the right for forward
drilling/fastening or to the left for reversing the
operation. Use the “reverse” setting only to
remove screws or to release jammed drill bit.
WarninG! tO preVent SeriOuS inJury:
Do not change direction of rotation while
chuck is rotating.
Wait until Chuck has come
to a complete stop before changing direction.
3. If using the Drill to insert or remove screws, position
the driver tip in the screw to insert or remove.
4. If drilling a hole, hold the Drill above the area to drill.
5. Press the Trigger to start the drill and release
the Trigger to stop the drill. The Work Light
will activate when the Trigger is pressed and
turn off when the Trigger is released.
6. Turn Torque Adjustment Ring as desired.
7. When inserting or removing a screw or bolt, use
slight pressure at first to keep the screw driver bit in
the head of the screw or bolt and cause the screw
or bolt to thread into or unthread from the material.
8. When drilling a hole, let the Drill do the work,
using only enough pressure to follow the
drill as it cuts the hole in the material.
9. When finished using the Drill, release the
Trigger and center the Direction Switch to lock
the trigger mechanism as a safety measure.
10. To prevent accidents, turn off the tool and
remove its Battery Pack after use. Clean, then
store the tool indoors out of children’s reach.
