Page 5
For technical questions, please call 1-888-866-5797.
Item 56478
Sa
FE
ty
Op
E
ra
ti
O
n
Maint
E
nanc
E
S
E
tup
5. Slide an Extension Arm assembly all the way
into one end of the Main Frame (20).
6. Thread a Lock Knob (13) into the hole
on the side of the Main Frame.
7. Adjust the Arm assembly to the desired
length and secure to the Main Frame by
twisting the Lock Knob until tight.
8. Repeat for the other Arm assembly and secure
it to the other end of the Main Frame.
9. Attach the Miter Saw (not included) to the
two Mounting Brackets (21) using four
Carriage Bolts (29), Flat Washers (30),
Spring Washers (31), and Nuts (32).
note:
The two Mounting Brackets must be parallel
to each other. If the miter saw does not have at least
four mounting holes that line up with the bolts on the
Mounting Brackets, it will need to be attached using a
universal mounting platform, as explained on page 6.
WarninG!
Included Carriage Bolts (29) may be too
long or short for your miter saw. They must properly
secure the miter saw to the brackets, thread all the
way through the washers and nut, and not interfere
with the safe operation of the saw in any way.
Replacement bolts can be used instead, but they must
be grade 5, have the same head type and size as the
included Bolts (29), and have a 1.0mm thread pitch
and M6 thread diameter. They also must properly
secure the miter saw to the brackets, thread all the
way through the washers and nut, and not interfere
with the safe operation of the saw in any way.
nOticE: Be sure Brackets are installed
correctly. Do not install them backwards.
Extension
arm
assembly
Main
Frame
(20)
Lock
Knob
(13)
(32) Nut
carriage Bolt
(29)
Flat Washer
(30)
Spring
Washer (31)
nut (32)
Mounting
Bracket (21)
Miter Saw
incOrrEct! Brackets backwards.