WINCH MANUAL
HOW TO FIx THE CLAMp (HOIST MODELS ONLY)
9
HOW TO FIx THE CLAMp
(HOIST MODELS ONLY)
1. Prepare the suitable fittings: 5MM Internal Hex wrench, 10MM Open
End wrench, as shown in photo.
2. Adjust the drum to make the screw hole on the top, put the rope on
the drum and put the clamp on the rope (the hole close to casting
plate)
3. Press the clamp to the drum and make sure the rope is in the groove
of clam. Adjust to the same position of holes in clamp and drum.
4. Put the bolt M6 X 65 in and go through out from another hole.
5. Then screw the cap of bolt.
6. Use fittings to fix firmly.
7. Use wrench to screw in M8 X 15bolt from the top hole.
8. Finished.
