Warrior, Inc.
11100 SW Industrial Way
Tualatin, OR 97062
Phone: (888) 220-6861
Fax: (503) 692-0364
KIT CONTENTS:
Item
Qty
Item
Qty
License Plate Mount
1
¼ x 1” Button Head Screw
6
LED license plate light
1
¼” Flat washer
12
Rubber edge trim
6 inches
¼” Nyloc nut
6
#6 x ½” black Torx screw
2
IMPORTANT INSTALLATION NOTES:
This Warrior Products license plate mount is
designed specifically for use with Warrior rear MOD
bumpers for the Jeep JL/JLU application where the
factory license plate location is on the rear bumper.
Some or all of the initial assembly steps may have
already been completed, in which case you may
skip that step.
1.
Begin by passing the wires of the light
through the top-middle slot of the bracket.
2.
Position the light against the mounting tab
as shown with the wires facing away from
the tab (the curved edges of the light will be
against the tab, and the sharp edges will be
away from the tab).
3.
Align the holes of the light with the
corresponding holes in the tab.
4.
Attach the LED light by inserting the two #6
black Torx screws through the holes in the
mounting tab and into the plastic housing of
the LED light.
5.
Tighten the screws with a T15 Torx driver until
snug (overtightening may cause damage).
