INTIG 316/501 AC/DC
- 11 -
A.
Grid voltage abnormity indicator: when the input voltage is not within 380-440 vac or lacks
phase, this indicator is on.
B.
Overload indicator: when the ambient temperature is too high, or the machine is used over the
rated duty cycle, which causes the overheat inside machine, this indicator is on.
C.
Water cooling abnormity indicator: when the water cooling torch is used, it shows the water
pressure status. When the water pressure is enough, the indicator is off, when the water pressure
is not enough, the indicator is on.
9). Back panel picture and introduction:
A.
Power protection switch: it only used for protection of the over load current.
B.
Power input cable: the three phase input cable is fixed on the machine through the screw
connector.
C.
Communication interface A: it connects the pedal controller (INTIG 316 AC/DC) or the same
frequency communication interface of double machine (INTIG 501 AC/DC).
D.
Communication interface B: it connects wireless controller.
E.
Silk print place of name plate.
F.
Label place for welding machine series no..
G.
Installation place of wireless controller.
H.
Cooling fan.
I.
Water-returning connector.
J.
Water inlet connector.
K.
Gas inlet connector: it connects argon relieve valve.
10).Front below panel introduction:
A
B
F
G
K
I
H
J
C
D
E
A
B
C
D
E
F
