WARN® INDUSTRIES
PAGE 1
79959 Rev A1
WARNING
Always
Read the Plow Operator’s Manual, the Winch Operator’s Manual and all warning labels before operating.
Always
remove jewelry and wear eye protection.
Always
use appropriate and adequate care in lifting components into place.
Always
insure components will remain secure during installation and operation.
Always
tighten all nuts and bolts securely, per the installation instructions.
Always
operate the vehicle at a walking speed with the blade installed. Never exceed 5 mph (8 km/h), even with blade up.
Always
plow cautiously, impact with hidden or stationary object may cause the vehicle to stop suddenly or go out of control.
Never
operate the vehicle on slopes greater than 10 degrees with the plow installed.
Never
stand or ride on the plow.
Always
stay clear of moving parts and joints. Always keep others away when operating or adjusting plow.
Always
perform regular inspections and maintenance on the plow mechanism, fasteners, cable and related hardware.
Always
replace all worn or damaged parts before operating.
Never
operate this WARN product with damaged or missing parts.
Always
drive slowly over bumpy and rough terrain. Driving at speeds that cause the plow to bounce while in the up position can cause the
winch to back-drive, causing the plow to work its way down. This may result in the plow impacting a stationary object and cause damage to
the vehicle and operator injury or death.
Always
drive at speeds such that the plow does not bounce and be aware of the plow position while driving at all times.
Never
raise the top of the plow above the headlights of the ATV, as it may damage the vehicle and plow.
INJURY HAZARD
Failure to observe these instructions could lead to severe injury or death.
Your safety, and the safety of others, is very important. To help you make informed decisions about safety,
we have provided installation and operating instructions and other information on labels and in this guide. This
information alerts you to potential hazards that could hurt you or others. It is not possible to warn you about all
potential hazards associated with this product, you must use your own good judgment.
CARELESS INSTALLATION AND OPERATION CAN RESULT IN SERIOUS INJURY OR EQUIPMENT DAM-
AGE. READ AND UNDERSTAND ALL SAFETY PRECAUTIONS AND OPERATING INSTRUCTIONS BE-
FORE INSTALLING AND OPERATING THIS PRODUCT.
This guide identifies potential hazards and has important safety messages that help you and others avoid personal
injury or death
. WARNING
and
CAUTION
are signal words that identify the level of hazard. These signal words
mean:
WARNING signals a hazard that could cause serious injury or death, if you do not follow
recommendations. CAUTION signals a hazard that may cause minor to moderate injury, if you do not
follow recommendations.
This guide uses
NOTICE
to call attention to important mechanical information, and
Note
: to emphasize general
information worthy of special attention.
INSTALLATION INSTRUCTIONS
ProVantage 72” Plow Blade Kit
Part Number: 79958
Application: SxS Vehicles
