©2011 Warn Industries, Inc.WARN® and the WARN logo are trademarks of Warn Industries Inc.
6
87731A0
I N S T A L L A T I O N I N S T R U C T I O N S
6.
Align holes in frame mount bracket of bumper weld-
ment with holes in wings of rear crossmember, as
shown in Figure 7. Loosely attach with four 3/8-16”
hex head bolts, flat washers and lock nut. A flat
washer should be used under head of bolt and on
top of locknut. A 9/16” socket and wrench can be
used to loosely secure.
7. Tighten all hardware, making sure that u-bolts are
not binding on frame tubes. Check for adequate
clearance with radiator hose and rear crossmember
on passenger side of vehicle.
8. After all other fastners have been tightened, install
cross member support bracket (A4). It attaches to
the back side of the (A2) and then to the frame of
the vehicle. Refer to the exploded view for attach-
ment.
Torque u-bolt nuts, as shown in Figure 4, to recom-
mended specifications of 8lb. ft (10.8 N-m). Torque
M8 x 1.25 hardware on bottom of front armor plate,
as shown in Figure 3, to recommended specifica
-
tions of 17lb.ft. (12.5 N-m).
9. Torque 3/8-16 hardware on bottom of bumper
weldment and joint between frame brackets/rear
crossmember, as shown in Figure 5 and 6 to recom-
mended specifications of 30 lb. ft. (40.7 N-m).
10. See Figure 9 for view of completed installation.
Figure 7
Figure 8
Figure 9
