5 80655A1
I N S T A L L A T I O N I N S T R U C T I O N S
Operation
Attaching the plow to the vehicle:
1. Stage the plow assembly on level solid ground. See Plow
operator guide “Installing the Plow” for more information
on installing plow mount flange (A3). See Figure 4.
2. SLOWLY drive the vehicle up to the plow assembly with the
vehicle as square to the plow as possible.
3. Turn off the vehicle and set the parking brake. Lift the plow
mount flange end of the push tube assembly up to the
plow mount on the vehicle. Insert the plow mount flange
into the plow mount receiver. See Figure 5.
4. Double check that the plow is fully engaged with the align
-
ment pucks on the plow mount flange. The alignment
pucks should be fully seated into the plow mount cradle
feature.
5. With both alignment pucks seated into the plow mount the
retaining pins can be inserted. Once inserted the retaining
clips on the pins can be clipped onto locking tab on plow
mount, refer to Figure 6. See Plow operator guide “Install
-
ing the Plow” for more information.
6. With both retaining pins secure, pull out the line from the
winch.
7. Pull the retaining pin on the plow assembly that is secur
-
ing the pulley assembly. With the pulley assembly loose,
place the pulley assembly over the winch line and reinstall
the pulley assembly onto the push tube assembly securing
the pulley assembly with the retaining pin. See “Double
Line Rigging” in the Plow Lift section of the Plow Operators
Guide.
Figure 6
Figure 4 Install Plow Mount Flange
Figure 5
Retaining
Pin
A3