WARN® INDUSTRIES
PAGE 7
79671A2
©2011 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
Figure 10
1/4-20 capscrew and locknut
Figure 11
2.
Install the lower plow mount support bracket on
crosstube of vehicle frame, as shown in Figure
10. Use the 1/4-20 u-bolts and 1/4-20 locknuts
to secure in place, but do not tighten at this time.
Lay the plow mount assembly on top of the
bracket and lean against the rear frame to get
the correct orientation. Remove plow mount
assembly and torque u-bolt mounting hardware
to 8lb. ft. (10.8 N-m).
3.
Place plow mount assembly on top of lower
mounting bracket. Line up holes and use 1/4-20
capscrews to secure in place as shown in Figure
11. Torque 1/4-20 nuts to 8lb. ft. (10.8 N-m).
4.
Install 5/16-18 u-bolts around vehicle frame and
through back side of plow mount assembly as
shown in Figure 12. Torque hardware to 17lb. ft.
(22.5 N-m). Once mount is secured in place,
replace the front aluminum skid plate on vehicle,
shown in Figure 7 of previous section. Some
trimming may be required in the area of the plow
mount allowing skid plate to bolt up to original
mounting location. See Figure 8 of previous
section for completed installation.
Figure 12
Lower mounting bracket
5/16-18 u-bolts
V. Rincon Installation continued
