WARN INDUSTRIES
PAGE 10
73465 A2
the bracket hole to 1/2”. On all vehicles, drill out the threaded hole to 1/2” and continue drilling through the
upper cross member wall.
Note: Do not drill into the radiator.
Figure 15 and 16
Figure 16 Left side transmission cooler line bracket with hole enlarged to 1/2”
18. Slide the bumper onto the eight bumper beam studs. The Frame Brackets should be
outboard
of the
Bumper Gusset Plates. Install the original 12mm flange nuts. Do not tighten yet.
19. Hold the RH Cross Member Bracket in place against the cross member and insert a 1/2 x 2 1/4” bolt
and flat washer through the Bracket and cross member. Install a 1/2” flat washer, lock washer and nut. Do
not tighten yet.
Figure 17
Figure 17 RH Cross Member bracket installed
Transmission
cooler line bracket
(some vehicles)
RH Cross Member Bracket
