©2023 Warn Industries, Inc.WARN® and the WARN logo are trademarks of Warn Industries Inc.
6
110784A0
I N S T A L L A T I O N I N S T R U C T I O N S
17. While holding light port (A8 or A9) in place, secure
with ten stainless screws (B1), lock washers (B3),
flat washers (B4) and nuts (B2). Repeat for other
side. Review exploded view on page 3.
18. Install three 1/2” bolt strips (A5) into the inside
of the bumper mounts and secure them in place
using the bolt retainers (B14). Repeat for other
side.
TIP: Using a 3/4” deep socket can assist in pushing
the retainers flush against the mount.
19. If vehicle is equipped with parking sensors,
reinstall the parking sensor housings and sensors
into their respective locations and orientations.
If vehicle is not equipped with parking sensors,
install the provided rubber grommets (B15) and
plastic plugs (B16) into the cutouts.
For illustration purposes only
Park Sensor Harness
Sensor
Sensor
Housing
Sensor
Plug
20. Apply the provided epoxy on the inside of the
bumper around the sensor housing to hold them
in place.
21. Find the protective filler panel (A7) for the ACC
sensor. With the smooth side facing up against
the bumper wall of the opening of the bumper,
trace the bumper opening and mark the two screw
holes.
22. Using a tab measure, mark an offset line to the
previously marked line, by 5/8 inch.
23. Using a knife, cut along the offset line.
24. Use a 5/16” drill bit to drill out the two marked
holes in the panel.
1
2
1
2
3
4
5
16ths
Offset
Line
Offset
Line
Drill Hole