7
NOTE:
If pairing was successful, the LED
(B)
will turn green. The device is
now ready for use. If the LED turns red you will have to try pairing the device
again.
Once the eTRV has successfully paired to the Smart Hub,
programming of the device or changes to device settings must be
done through the konekt app.
If required, you can quickly switch between manual or program
mode on the eTRV by pressing and holding the Menu/Boost button
(E)
for 2 seconds.
You can manually start pairing mode for another 3 minutes by
pressing the system button
(B)
once.
5.2 Mounting
The eTRV is easy to install and can be done
without draining the heating system as
long as you have radiators with a suitable
radiator valve.
The union nut
(G)
on the eTRV can be
directly attached to all valves with a
standard thread size of M30 x 1.5.
5.2.1 Danfoss RA adapter
The adapter provided is required to attach the eTRV to Danfoss RA valves.
The RA adapter is pre-tensioned in order to provide a better fit. If necessary
use a screwdriver to open the adapter slightly. The Danfoss valve bodies
have elongated notches around their circumference, which also ensure that
the adapter is properly seated when it snaps on.
During installation, ensure that the
pins inside the adapter are lined
up with the notches on the valve.
Ensure that a suitable adapter
for the valve is properly clipped
on. After clipping onto the valve
body, attach the adapter using the
provided screw and nut.
1
2
RA
1
2
5.2.2 Support ring
The valves from different manufacturers may
have tolerance fluctuations that make the eTRV
sit more loosely on the valve. In this instance,
insert the provided support ring into the flange
before mounting.