Warmtech TCPM2000, Instruction Manual

Page: 12 / 21

12
OPERATION INSTRUCTIONS
a)Connect the appliance to the mains.
b)Turn to the maximum the thermostat
switch
c)select the desired temperature by pressing
power switch (750W/1250W/2000W)
d)With turbo mode will get a faster
heating environment by turbine.
e)When the desired temperature has
been reached ,turn left the thermostat until the
appliance will be on and off by itself on the
selected temperature previously.
INSTALLATION
Before switching on the appliance and in
order to assure its correct performance, set the
feet-support.
(1)To the lower parts of the apparel,
matched at the same time, inside the grooves
of the metallic cover.
(2)Then fix both by means of the screws
soothed with the appliance.
MAINTENANCE
1)Donot cover the outlet as it might
cause overheating.
2)Always maintain clean the outlet and
inlet grilles.
3)Disconnect the appliance from the
mains before cleaning.
4)Clean the outer pan of the appliance
with a soft cloth gently wet. Never use abrasive
nor dissolvent.
5)Never hand the appliance with wet
hands.
6)When the appliance is on again after
a long tine bing stopped, a burn smell will
probably give off, due to the dust on the
resistances.
TECHNICAL ASSISTANCE SERIVCE
All the appliance have been checked
before leaving the factory ,Despite of it ,if you
observe a failure, remember that the Technical
Assistance Service will remain at your request.
If the plug has electricity
If all instruction for the starting
have been observed .
After these operations, if the appliance
should not work ,do not hesitate in calling us
,providing us model and serial number.
PARTS OF CONVECTION HEATER
ASSEMBLY OF THE HEATER
Before using the heater, the
feet (supplied separately in the carton), must
be fitted to the unit. These are to be attached
to the base of the heater using the 4 self-
tapping screws provided, taking care to ensure
that they are located correctly in the bottom
ends of the heater side moulding.
CLEANING THE CONVECTOR
Unplug the convector before cleaning and
leave it to cool down entirely.
Wipe the unit with a soft, non-abrasive
damp cloth.
Do not use any kinds of detergents or
chemical based cleaners on the unit as it may
damage the body.
NEVER IMMERSE IN WATER
when storing, stand in an upright
position in a cool, dust free place-preferably in
it is packaging.
This guide is intended to help you install and
care for your fan heater.
Please read all documentation carefully before
installing and using your heater.
Important: Please keep your guide in a safe
place for future reference.