Warmtech RCM2002TL, Original Instructions Manual

Page: 11 / 21

11
· Attention!
To avoid any danger due to
unintentionally resetting the thermal cut-out, the
appliance must not
be supplied via a timer.
·
The appliance is not suitable for animal breeding
purposes!
·
The instruction leaflet belongs to the appliance and
must be kept in a safe place. When changing
owners, the leaflet must be surrendered to the new
owner!
IMPORTANT
–
_ Damaged switches must be replaced by our after-
sales service department.
_ If the connecting cable (or mains plug) is
damaged, it must be replaced by a particular
connecting cable which is available from our service
department. Replacement of the connecting cable
must only be carried out by our service department
(see last page) or by a qualified person (qualified
electrician).
Symbols :
Warning / Danger!
In accordance with
essential applicable
safety standards of
European directives
Double insulated
PACKAGING
·
After unpacking the appliance, check the same for
transport damage and the contents for
completeness!
In the event of damage or an incomplete delivery,
contact your authorised retailer!
·
Do not discard the original box! It can be used for
storage and dispatch to avoid transport damage!
·
Dispose of the packaging material in a proper
manner! Plastic bags should be kept away from
children!
WARNING: Packaging materials
are not toys!
Children must not play with plastic
bags!
Danger of suffocation!
START UP
·
After switching on the appliance for the first time
and after an extended period of non-use, a smell
may be noticed for a short time.
·
To use, insert the plug in the socket.
OPERATING INSTRUCTION
I Characters of the product
This product uses electrical heater and
has high efficiency. There is not any
open flames and oxygen consumption.
The solid high-quality plastic housing
has a long life span.
The product releases low noise. The
ventilator is calm and pleasant, and
produces a gentle wind stream.
The two-stage Temperature is suitable
for the different areas.
II Technical Data
Type RCM2002TL
Specification remote control
Voltage 220-240V~
Frequency 50Hz
Power 1000W/2000W
III How to put on the wall?
Bore 2 holes, which 1.8 m over the floor, on the
wall. The hole diameter must be sufficient for the
plastic pegs. Put plastic pegs into the holes. Fasten
the hanging hooks with screws in the pegs. Check if
the hanging hooks are firm and stable and hang the
product up to hooks. The lower claws of the hanging
hook must sit in the gutter hole at the bottom of the
product. See the photo1