8. SECURE WIRES
Your WarmlyYours FeelsWarm® Countertop Heater is supplied with a packet of Velcro patches, a strap, and screws to
secure the wires inside the cabinet. Because the length of the wires provided often exceeds what is needed, WarmlyYours
recommends securing the wires to keep them out of the way of normal activity. To apply each patch, peel the clear release
liner off one half of the Velcro patch and stick it onto the cabinet wall. Secure the wires using the matching Velcro piece. If
the velcro doesn’t stick to your cabinet wall, use the strap included. Cut the strap to the desired length and drill the screws
into the cabinet wall to secure your transformer and access cord.
9.TURNING HEATER ON
You can turn on your WarmlyYours FeelsWarm® heater immediately. If your heater does not include a Thermal Control
Unit, turn the heater on by plugging in the transformer to your outlet. To turn the heater off, unplug the transformer.
If your heater does include a Thermal Control Unit (TCU), the temperature can be adjusted down from the automatic
maximum temperature of the heater and it also provides a quick on/off method. Once the transformer is plugged into
your outlet, the TCU will light up. Use the small button on the TCU to change the settings. The red light indicates the
heater is OFF. The single green light indicates the heater is receiving power. The yellow lights indicate the setting of the
temperature level.
It is recommended to set your TCU at HIGH for the first 24 hours. This is the most common setting and most likely the
desired temperature. The heater automatically raises the temperature of the countertop approximately 20 degrees
Fahrenheit above the room temperature when set at HIGH. If the room temperature is elevated, then either turn the TCU
to OFF or adjust it toward LOW in various increments. Typically, once the desired temperature of the countertop has been
established, the need to make changes to the temperature is infrequent.
Installation Instructions
SECTION
2
9
