background image

Electrical Safety

Class 1 Configuration

The wires in the mains lead are coloured in accordance with the following code:

GREEN/YELLOW: EARTH (E)
BLUE: NEUTRAL (N)

BROWN: LIVE (L)

 

 

 

 

 

                 Class 1 Configuration

As the colours of the wires in the mains lead of this appliance may not correspond 

with  

 

the coloured markings identifying the terminals in your plug, pro-

ceed as follows:

The wire which is coloured GREEN & YELLOW (or coloured GREEN) must be con-
nected   to the terminal in the plug which is marked with the letter “E” or by the 
earth symbol     .

The wire which is coloured BLUE (or coloured BLACK) must be connected to the 
NEUTRAL terminal which is marked with the letter “N”.

The wire which is coloured BROWN (or coloured RED) must be connected to the 
LIVE  

terminal which is marked with the letter “L”.

Always ensure that the Mains Cord is fixed into the plug through the Cord Guard or 

Cable Clamp, (plug wiring diagram above), and that the Cord Guard screws are tight-
ened to clamp   the cord (outer sheath and inner coloured wires) into position in 

the plug. Make sure that the plug top is also fitted securely.

This appliance must be protected by a 5 Amp fuse in a 13 Amp type (BS1363) plug. 
Should you need to replace the fuse, use only a 13Amp ASTA approved BS1362 fuse 
(13A).

OPERATIONAL GUIDELINES

It is important to ensure the correct Plug Adaptor is used when operating 

in a country not using the UK 13 Amp socket system. If in doubt, consult a qualified 

electrician.

              Product Helpline.   

0871 221 3618 

For all your product needs.

              Product Helpline.   

0871 221 3618 

For all your product needs.

Instructions on Use 

Plug the appliance directly into the mains power socket and switch on at the socket.

Do not use any form of adaptor, extension lead or timer 

Press switch 1 to operate the flame effect and turn the fan on without the appliance 

producing heat

Where heat is required. 

For Low Heat  (1000W) press switch 2  (The red light on the switch will show that 
the switch has been engaged).
For High Heat press switch 2 and 3 (The red light on the switches will show that the 

switch has been engaged).
Once the appliance has been set for high heat the temperature can be lowered and 

raised by the thermostatic control 4 this is done by rotating the controller to the 
right or left until the correct temperature is found.

The brightness of flame effect also can be altered to the required level by rotating  

the controller to the right or left until the correct brightness is found.

Cleaning and Maintenance

Before commencing cleaning ensure that the appliance is disconnected from the 
mains power supply and it has cooled fully.
Clean the appliance with a soft lint free damp cloth (for stubborn stains a little deter-
gent may be used) always allow to dry completely before using the appliance.

Changing the Bulb 

This appliance is fitted with two 40W E-12 bulbs and may need to be replaced from 

time to time 
When the bulbs need to be replaced 
1. Loosen the two screws on the panel at the back of the appliance 
2. Remove the grill to achieve this pull toward you and lift upwards
3. Replace the bulb/s 
4. Re-assemble the appliance this is done by reversing steps 1 and 2

Using the thermostat

The thermostat will constantly maintain automatically the temperature that you set

It is recommended that the thermostatic controller is set to the highest heat at first 

and when the room is at the desired temperature the controller can then gradually 
turned down until the appliance is holding the temperature at the required level.

Reviews: