9
www.warmlite.co
Manual Operation:
•
Switch on the standby switch at the left hand side
of the fire canopy.
•
Press the O/I button once to turn on the appliance
and fire effect. A red indicator light will appear to
indicate that the function is ON.
•
Press the O/I button for 3 seconds this will operate
the dimmer mode. There are 5 levels of flame
brightness available.
•
Press the 1000W button once for the low heat
setting. A red indicator light will appear to indicate
the function; press twice to switch off the heat
setting.
•
Press the 2000W button once for the high heat
setting. A red indicator light will appear to indicate
the function; press twice to switch off the heat
setting.
Remote Operation:
Adjusting the Flame Effect Brightness:
•
Press the “DIMMER” button on the remote control
to operate the dimmer mode. There are 5 levels
flame brightness available. The flame brightness
changes, step by step, with each press of the
button.
Setting the Time and Date:
•
Settings are made using the remote control.
•
Press the “DATE TIME” button, then press the “
▲
”
or “
▼
” button to select the date.
•
Press the “DATE TIME” button again, then press
the “+” or “-” button to set the hour.
•
Press the “DATE TIME” button again, then press
the “+” or “-” button to set the minute.
•
Press the “OK” button to confirm and complete.
Selecting the Temperature:
NOTE:
The set temperature must be higher than the
room temperature for the heat to be emitted.
•
Press the “+” or “-” button on the remote control
to set the temperature, which ranges from 15 to
30℃. The default set temperature is 20 ℃.
Selecting the Heating Operation:
•
Press the ON/OFF button once on the remote
control to turn the fire and flame effect ON/OFF.
•
Press the “1000W” button once to turn the low-
level heating on and press twice to stop heating.
•
Press the “2000W” button once to turn the high-
level heating on and press twice to stop heating.
NOTE:
The set temperature must be higher than the
room temperature for heat to be emitted.
The AUTO Function (Intelligent Control):
•
Press the “IC” button on the remote control to turn
the automatic heating ON or OFF.
•
When turned on, the fire will automatically
change the heating mode depending on the set
temperature and the room temperature.
•
During a timed starting process, it is possible to
start heating ahead of schedule.
NOTE:
The set temperature must be higher than the
room temperature for heat to be emitted.
The Timer Function:
•
Up to 10 different timer settings can be
programmed.
•
Each timer setting consists of a Date, Timer ON
time and Timer OFF time.
•
The maximum duration of each setting is 23 hours
50 minutes.
•
The date for each setting can be any day or days
of a week.
•
The date in each timer setting represents the date
of the Timer ON time.
•
If the Timer OFF time being set falls on the second
day, it is unnecessary to set the date – you just set
the Timer OFF time.
Setting the Timer:
1.
Select the settings
•
Press the “TIMER SET” button, and the “serial
number” of the setting starts blinking.
•
Press the “+” or “-” button to change the “serial
number” until you arrive at the serial number of
setting that you need to set or modify.
2.
Select the date
•
Press the “TIMER SET” button once again, and the
cursor on the left side of date starts blinking.
