Warmlite CAMBRIDGE WL45043, Instruction Manual, Page: 9 / 16

9 www.warmlite.co
HANDLING
Before continuing any further with the
installation of this fire please read the following:
• Two people should be sufficient to lift the
fire.
• When lifting always keep your back
straight. Bend your legs and not your
back.
• Avoid twisting at the waist. It is better to
reposition your feet.
• Avoid upper body / top heavy bending.
Always bend from the knees rather
than the waist. Do not lean forward or
sideways whilst handling the fire.
• Always grip with the palm of your hand.
Do not use the tips of fingers for support.
• Always keep the product as close to the
body as possible to prevent unnecessary
and undue strain on the body.
• Use gloves to provide additional grip.
• Always use assistance if required.
USING YOUR APPLIANCE:
The appliance is operated through the switches
and temperature control dial located inside the
main door of the fire.
Turning the Unit On and Off:
• When turning the unit on, make sure the
ON/OFF switch, located on the right side
panel, is in the OFF position. Plug the
power cord into a 220~240 grounded
outlet.
CAUTION! Make sure the outlet is in good
condition and that the plug is not loose. NEVER
exceed the maximum amperage for the circuit.
DO NOT plug other appliances into the same
circuit.
• Flick the On/Off switch on the unit’s main
body to the ‘On’ position (represented by
the symbol ‘I’) to turn it on. The LED flame
effect will come on to indicate the unit is in
operation.
• Flick this switch to the ‘Off’ position
(represented by the symbol ‘O’) while the
unit is in operation to turn it off. The LED
flame effect will turn off to indicate the unit
has been turned off.
Selecting the Heat Setting:
• This unit is equipped with a choice of
1000W or 2000W heat settings.
• Flick the corresponding switch on the
unit’s main body to the ‘On’ position to
select each of the two heat settings. Flick
the ‘I’ switch to the On position for the
Low heat setting, or the ‘II’ switch for the
High heat setting.
NOTE: Always ensure the ‘I’ switch is set to
the ‘On’ position before turning on the ‘II’ heat
switch.
• Flick either or both of these switches
to the ‘Off’ position when the unit is in
operation to turn the heating function off.
NOTE: The LED flame effect operates
independently from the heating function, and
will stay on even after the heat switches have
been set to the ‘Off’ position.