Warmlite CAMBRIDGE WL45043, Instruction Manual, Page: 10 / 16

10 CUSTOMER SUPPORT TEAM:
+44 (0) 333 220 6056
Selecting the Temperature:
• Once the desired heat setting has been
activated, the actual heating temperature
within the selected range can be adjusted
using the unit’s thermostat dial.
• Rotate the thermostat dial clockwise (to
the right) to increase the temperature, or
counter-clockwise (to the left) to decrease
it.
NOTE: The thermostat dial must be rotated
clockwise before heat begins emitting from the
unit. There will be a clicking sound to indicate
the heating function has been activated. The
same clicking sound will indicate the heating
function has been turned off when the dial is
rotated counter-clockwise.
NOTE: Once the desired ambient temperature
is reached, the heater will automatically stop
heating. Whenever the ambient temperature
drops more than 2°C below the desired
temperature, the heater will resume operation.
Safety Cut-Out:
• This appliance is fitted with a safety cut-
off device, which will operate if the fire
overheats (e.g. due to blocked air vents).
For safety reasons, the fire will NOT
automatically reset.
• To reset the appliance, disconnect the
appliance from the mains supply for at
least 15 minutes. Reconnect to the mains
supply and switch on the appliance.
• If the fire fails to operate, check the fuse in
the plug. If the fuse in the plug is OK and
the fire is still not functioning, contact a
qualified service person.
CAUTION! Do not touch the fire as it will be
hot. Set the heater switches to OFF and leave
the fire to cool down fully. Once completely
cool, reconnect the heater and switch it on.
Do not open this product. There are no user-
serviceable parts inside.
CHECK THAT YOU HAVE NOTED ALL THE
FOLLOWING INSTRUCTIONS:
Do:
• Always install the fire in accordance with
this guide. If in doubt obtain expert advice.
• Always make sure the electrical socket is
accessible and located adjacent to, but
not above or behind the fire.
• Always disconnect the fire from the
electrical supply before carrying out
cleaning or maintenance.
• Always make sure the fire is firmly
secured.
• Always assemble the fire in accordance
with this guide. If in doubt, obtain expert
advice.
• Always ensure the product is assembled
in an area that is free from dust, grease or
liquids.
• Always ensure that the correct tools are
used to assemble/install this product.
• Always make sure the fire is firmly secured
in place when complete.
Don’t:
• Never leave children unsupervised in a
room where the fire is ON and unguarded.
• Never obstruct or cover the fan outlet or
force items into the fire openings.
• Never install or use the fire anywhere
where water is in use, i.e. bathrooms,
kitchens, shower rooms, swimming pools
etc.
• Never use aerosols or steam cleaners on
or around the fire.
• Never route the mains supply cable under
carpet etc.
• Never install the fire close to curtains or
combustible materials.
• Never use the fire to dry clothes etc.
• Never sit or stand on the fire.
• Never cut the off the plug and hard wire
into a fixed fused spur.