14 June 2016
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
All Dimension are in mm……..Copyright ©
13
Note:
When the Base screw is removed, gas will leak from the out let, ensure that the pilot is not adjusted
or the screw is removed when the fire is burning.
Adjustment of Pilot - 3 Flame : Unscrew Base Screw as shown in Diagram 2 .
Insert a Screw Driver as shown in Diagram 3 and adjust the Adjustment Screw up inside the 3
Flame Pilot to adjust the Flame Height .
The Flame must always be passing over the Electrodes &/or File Tube on either side .
Replace the Base screw and check for leaks.
ADJUSTMENT OF HI
—
LOW PRESSURE (SG ONLY ) (Only to be Adjusted by Gasfitter)
ADJUSTMENT OF THE PILOT
—
3 FLAME (BOTH SG / EG) (Only to be Adjusted by Gasfitter)
Note* Control Valves are Factory Set but may require adjustment onsite .
Turn Appliance Off & Remove Front Plastic Cover on Igniter , Pull Cover to Slide off .
Unscrew Test Nipple on the Burner Manifold & fit the Test Gauge Securely - See Diagram
* To Set the High : Light the Burner & turn to High - Then Adjust the High Screw to the Desired Pressure . See Spec’s
* To Set the Low : Light the Burner & turn to Low - Then Adjust the Low Screw to the Desired Pressure . See Spec’s
Extinguish Appliance, remove Test Equipment and Secure Test Nipple .
* Check Valve & Burner for Correct Operation & check Fire for Gas Leaks .
Adjustment of High & Low Settings Must be Carried out by a Certified Gas Fitter Only
.
3 Flame Pilot in
Assembled State
Correct Operation of
3 Flame Pilot
3
2
Note: to Gas Fitters
The 3 flame pilot may need adjustment
after a period of running time on set up
as the increase in heat in the fire will
induce a higher draft in the fire, and
may pull in flame away from the File
Tube causing the fire to shut down.
Gas Test
Nipple for
SG / EG
Fires
