Using the Controller
•
Do not use any other controllers for this blanket.
•
The on/off switch is on the right-hand side of the controller. Push
upwards is ‘on’ and push downwards is ‘off’.
•
Press ‘body’ or ‘feet’ to adjust the temperature.
•
Press ‘body’ and the displayed temperature circulates from 0-9.
•
Press ‘feet’ and the displayed temperature circulates from 0-9.
•
When setting at a high temperature (5-9), it will automatically
change to a lower temperature after three hours.
•
Press ‘time’ to select the desired setting (1-12 hours). When the
timer runs out, it will change to standby.
•
Press ‘auto’ and it will automatically set heat setting 5 for three
hours.
•
If the controller shows ‘P’, it is possible that the controller coupler is
not connected.
•
If the controller shows ‘E’, please shut down and then restart. If it
still occurs, this indicates that the internal connection has short
circuited and that the blanket is damaged.
Preheating the Blanket
•
The controller has a pre-heat facility in order for you to warm your
bed prior to getting into it.
•
The time taken to preheat the bed will depend on the ambient
temperature of the bedroom and whether an electric blanket has
been used on the bed on a regular basis.
