11
To Clean the Melting Station
Due to the type of ingredients being melted in the melting pot,
it is best to empty and clean the melting pot immediately after
each melting cycle is complete.
Clean all parts by hand as
described below. Melting pot and parts are not dishwasher
safe.
1. Remove the melting pot from the base and remove the lid.
CAUTION: Melting pot and base are hot.
2. Remove the stirring arm from the lid by releasing the tabs
on the inside of the lid. Press down and out on the tabs
and gently pull the lid off. Wipe the stirring arm clean with a
damp, non-abrasive cloth.
Do not submerge the stirring
arm in water.
3. Wash the lid, stirrer and melting pot in the sink with warm
soapy water, being sure to remove all residue.
Do not use
metal utensils to scrape the inside of the melting pot.
NOTE:
If you find that ingredients are sticking to the bottom of
the melting pot, you can fill the melting pot with hot water up
to the max fill line. Replace the melting pot into the base, along
with the stirrer, lid and stirring arm properly assembled. Turn the
control knob to HIGH and run for approximately 3–5 minutes.
This will help to release any stubborn ingredients. After this,
repeat steps 1–3 above.
4. If any ingredients drip into the base of the melting pot, use
a damp, non-abrasive cloth to wipe clean.
CAUTION: HOT.
5. Be sure that all parts are thoroughly dry before
reassembling.
Any other servicing should be performed by an Authorized
Service Representative.