7
MMB160CE/K OPERATION
Follow steps 1–3 in the
MMB145CE/K operation section.
4. This blender is equipped
with an electronic membrane
keypad. The keypad has
hI, Lo, SToP and PULSE
buttons, as well as a
60-second countdown timer with Up and Down arrows
to set time. Always use hI speed for crushing ice. The
blender can operate in two modes: timer mode and
continuous mode.
5. For timer mode, press the UP or DoWN arrow to set
the desired time. The electronic timer will indicate run
time in 1-second intervals, up to a maximum of 60
seconds. Press and hold either UP or DoWN buttons
for fast scrolling. After the desired time is set, press
hI or Lo to start the blender. Green LED light will blink
during blending. The timer will count down to 0 in
1-second intervals and blender will shut off. Pressing
the PULSE button or the SToP button will override the
timer and the blender will stop regardless of time left on
timer.
NoTE: If you want to increase or decrease time while timer
is counting down, press UP or DoWN arrows. Time will
increase or decrease in 1-second intervals.
6. If the SToP button is pressed, the timer function will
turn off and the unit will return to continuous mode.
To reactivate timer, press UP or DoWN arrows. When
using the electronic timer again, the initial time will be
the last time set. Note: If unit has been unplugged, the
timer will default back to 5 seconds.
7. For continuous operation, press either the Lo or
hI button when timer is not lit. If the timer is lit and you
want to use continuous mode, press the SToP
button and proceed. When finished blending, press
