WAREMA Renkhoff SE
Hans-Wilhelm-Renkhoff-Straße 2 97828 Marktheidenfeld Germany
www.warema.com [email protected]
Fault: When operated, the product does not move to the desired lower limit position but switches off beforehand.
Cause
Note
Remedy
There is an obstacle along the path of
movement.
Remove the obstacle and try again.
Excessive wind load existed during
the movement to the lower limit posi-
tion.
If the wind load drops, the product
moves to the set position when a move
command is issued again.
Fault: The fabric is wavy in the lower limit position
Cause
Note
Remedy
The lower limit position is too low.
Set the lower limit position anew.
Fault: In Lamaxa L70, the drive was exchanged and interlocking (
"Interlocked units"
) is no longer functional.
Cause
Note
Remedy
The travel drive and tilting drive are
not a control package.
Use the WMS toolkit PC software to
unify the two drives to a single control
package.
