2024730_d•en•2020-01-01
We reserve the right to make technical modifications
8
Changing the wind speed limits (specialist
dealers only)
AUTION
C
Changing these settings may impair the
safety of the unit or reduce its effectiveness.
It is better to consult a qualified specialist
if you are not sure about the effects of a
change.
For your sun shading product to be protected properly, the
limit value above which a wind alarm is triggered needs to
be set for that particular product (type, width, projection,
etc.).
Set the limit values as required for your system (to the
most wind-sensitive product in the respective channel).
OTICE
N
How to change the limit values using a WMS
central transmitter is described in the operating
instructions of the WMS central transmitter.
Changing the wind speed limits with a WMS hand-held
transmitter comfort
The actual wind speed values in m/s represented by the
WMS hand-held transmitter comfort display are shown in
the tables in the previous section.
Button/
display
Action/result
The wind speed limit can only be changed if the WMS
Plug receiver was first learned into the WMS hand-held
transmitter comfort.
Select the product type and channel that
you wish to parameterise.
e.g.
The LED below the channel number lights
up
Press the mode button with a pointed
object until
lights up and mode 0 is
selected.
OTICE
N
The mode button must be pressed
before the WMS hand-held trans-
mitter comfort returns to sleep
mode.
If you press the mode button for
too long and a higher mode is
displayed: Release the button and
press and hold it again; the pro-
cess restarts at 0.
+
and the LED above the 0 light up in
red
Briefly press the learn button to activate
the mode.
The LED above the number 0 briefly lights
up in green
The sun control is displayed automatically.
Press the info button repeatedly until the
symbol for the wind monitoring lights up.
The LED below the control symbol shows
the state of the control function.
GREEN: Active
RED:
Inactive
Button/
display
Action/result
e.g.
...
The parameter value of the wind monitor-
ing is displayed in the upper row of LEDs
(here, limit value 2).
RED:
Value 0; the control function is
off
GREEN: Values 1 to 9
FLASHES: Multiple receivers with differ-
ent limit values in the channel.
The value of the first receiver is
displayed.
Use the arrow keys (
+
light up) to
change the parameter value.
e.g.
...
The upper row of LEDs shows how the
value changes (new value = 1)
Press the button
The transmission LED
lights up for 2
seconds
GREEN: The parameter value was saved
in all receivers of the channel
RED:
Not all receivers could be
reached; press the
button
again.
Leave the dealer mode with the mode but-
ton (
is no longer lit)
Cleaning
Photo sensors or solar panels must always be clean
to avoid incorrect measuring values and to ensure
operating reliability. The device should occasionally be
checked for soiling (e.g. bird droppings) and cleaned
carefully. Standard household cleaners may be used.
Do not use solvents.
In snowfall, check daily that the solar panel and pho-
todiodes are free of snow. A snow-covered weather
station may fail to function properly. If the energy in the
buffer is depleted, the weather station fails completely.
It resumes normal operation after it is recharged via
the solar panel.
The weather station may ice over and the wind wheel
may freeze up in extreme weather conditions. To avoid
wind damage, take your sun shading system out of
operation until wind monitoring can be resumed.
Never remove firmly attached layers of ice and snow.
Scratching, heat and chemical antifreeze agents may
damage the weather station.
