7
2018148_a•en•2017-04-01
We reserve the right to make technical changes
Button/
display
Cction/result
By pressing the UP and DOWN arrow buttons,
you can select the desired receiver/product
type:
Press UP
Flashing increases by one
Press DOWN
Flashing decreases by one
Depending on the frequency with which
the control function LED
flashes, the
corresponding product type is displayed:
1 x GREEN: Awning
2 x GREEN: Roller shutter
3 x GREEN: External venetian blind
4 x GREEN: Light
5 x GREEN: Window
To check which product type was set,
press the control button
.
The flashing of the control function LED
indicates which product type was
selected.
IUTCE
O
If the desired receiver is not wav-
ing after the control button
has
been pressed, a brief press of
the
button switches to the next
receiver found during the scan.
Press the STOP button
.
The appropriate product type is now as-
signed to the receiver.
The transmission LED
lights up for 2
seconds.
GREEO
This confirms the allocation.
IUTCE
O
The first receiver that is learned into the WMS
Hand-held transmitter plus defines the type of
channel that is selected.
If an external venetian blind is learned in as
the receiver first, the channel type is defined
as an external venetian blind channel and
only external venetian blinds can be learned
in.
Transmission LED
flashes.
GREEO:
The scan process is now repeated
automatically until no more new
devices are found.
The transmission LED
lights up.
IRCOGE:
The scan is ended.
Briefly press the learn button to leave the
learn mode.
Example 6:
Delete learned-in products from the WMS Hand-
held transmitter plus and the network
You can remove the learned-in products completely from
the WMS Hand-held transmitter plus and the network.
First, scanning is repeated (see example 5 on page 6)
to identify the learned-in devices.
IUTCE
O
Devices that do not need to be deleted must be
de-energised.
As soon as the transmission LED lights up orange, you
can start the deletion process.
Button/
display
Cction/result
+
Select the channel using the
+
button.
Press the learn button on the WMS Hand-
held transmitter plus for approx. 5 sec-
onds.
+
L LED
lights up green; the transmission
LED
flashes. For several seconds, the
hand-held transmitter scans the operating
range for receivers.
By pressing the learn button again, the
process can be aborted.
The L LED goes out.
If, while scanning, the WMS Hand-held trans-
mitter plus finds a target device (receiver,
transmitter, sensor) that has already been
learned in:
The transmission LED
lights up.
GREEO:
Lights up continuously for 2 seconds.
Then scanning continues.
The transmission LED
lights up for 2
seconds.
IRCOGE
Scanning stops.
+
Press the
STOP button
and
simul-
taneously.
The delete command is sent to all learned-
in receivers.
Those receivers that are still learned-in wave
when they are deleted from the WMS Hand-
held transmitter plus and the network.
The transmission LED
indicates the result
of the deletion process:
Transmission LED
flashes.
GREEO:
The devices are deleted.
Transmission LED
flashes.
RED:
Not all target devices have been deleted.
Press the STOP button
.
The deletion command is sent repeatedly
to find receivers that were not within the
radio range during the first deletion com-
mand and to delete them as well.
Briefly press the learn button to leave the
learn mode.