Tools required (not supplied)
• Electric drill, 2mm diam. wood drill bit and
6mm diam. masonry drill bit
• Crosshead screwdriver
• Handsaw (with appropriate blade for
cutting MFC)
• Hacksaw (32tpi blade recommended)
• Spirit level
• Bradawl
• Tape measure
• Pencil
INSTALLATION GUIDE
OFFSET SHELF STACK & HANGING RAIL
PACK
G
This pack contains:
• 1 x divider panel
(l)2070mm x (w)450mm x (d)18mm
• 1 x shelf support panel
(l)1720mm x (w)450mm x (d)18mm
• 1 x long shelf
(l)1600mm x (w)450mm x (d)18mm
• 1 x long shelf side bearer
(l)430mm x (w)87mm x (d)18mm
• 1 x long shelf back bearer
(l)1200mm x (w)87mm x (d)18mm
• 4 x shelves
(l)450mm x (w)364mm x (d)18mm
• 1 x hanging rail & fixing brackets
(l)1200mm
• Fixings - 18 x 34mm minifix bolts; 18 x minifix
housings; 2 x M10 direct drive screws; 9 x 40mm
screws; 9 x wall plugs; 5 x 25mm screws; 12 x 15mm
screws; 2 x plastic corner blocks; self-adhesive screw
head cover caps
Note: The kit can be installed with the divider panel
on the left (as shown) or it can be flipped so that the
divider panel is on the right - however, some of the
following instructions will need to be reversed
accordingly.
This information sheet provides details of how to construct and install an offset shelf stack and one hanging rail.
Please take time to read it through fully prior to the installation of your sliding wardrobe doors.
5
2
6
1 - Divider panel
2 - Shelf support panel
3 - Long shelf
4 - Long shelf bearers
5 - Shelves
6 - Hanging rail
1
1
3
4
