Quick Guide
Printing a File
1.
Turn on the 3D Printer, using the switch on the back of the Control Box. Once initiated, press
the Dial to enter the menu system. Navigate to, and select
Position > Z Pos.
Fast. Turn the
Dial to the rig ht to raise the Extruder to about 30mm. Press the Dial to return to the previous
menu and select back
2.
Navigate to, and select
Quick Settings
. Navigate to and select
Preheat PLA
. Wait for the 3D
printer to automatically return to the home screen, after approximately 15-30 seconds
3.
Check the temperature of the Extruder and plate on the LCD. When the temperatures are
within a few degrees of the target, you are ready to insert the filament.
NOTE:
Preheat PLA will still be shown, even after temperatures have been
reached. Insert the end of the filament into the hole on the Extruder as shown
4.
While holding the filament in place with one hand, press the Dial
to enter the menu system. Navigate to and select
Extruder > Extr
.
Position
. Gently push down on the filament while turning the Dial clockwise. You will feel
the filament being pulled into the Extruder. Continue until a few centimetres have
extruded out of the nozzle. Carefully clean the extruded filament off the Heated Print Bed
and nozzle using a cloth taking care not to burn yourself on the hot surfaces
5.
Insert the included MicroSD card into the slot on the side of the Control Box. Press the
Dial to enter the menu system. Navigate to and select
SD Card > Mount Card > Print File
AFTER SALES SUPPORT
86-571-23290996
Model : Duplicator I3 V2
16
IMPORTANT NOTE: Levelling the bed is an extremely important step and if it is not done
correctly every time, your prints will fail or be of poor quality
