50
MN-111 | Instructions for use | MN-111 W&H Med ENG Rev11 | 2019/01/25 | © 2019 W&H Sterilization Srl
Sterilization cycles
2
Check the cycle requirements.
3
Tap
to set a different start time.
See "Delay the sterilization cycle
start" below.
4
Tap
: the door locks. If you have
not set a different start time, the
sterilization starts immediately.
5
Wait the end of sterilization.
6
Tap
to view the cycle
information. See "View the cycle
parameters" on page 52.
7
The sterilization is completed. Tap
to view the cycle summary or
tap
to view the cycle
information. See "View the cycle
parameters" on page 52.
8
Tap OPEN: the door unlocks and the
homepage appears.
DELAY THE STERILIZATION CYCLE START
You may schedule the start of the sterilization cycles at a certain
date and time (e.g., if you want to load the sterilizer in the evening
and run standard sterilization cycle early the next morning before
office hours). You can set the cycle start date and time and enable
or disable it for each cycle.
Summary of Contents for MN-111
Page 1: ...MN 111 110 V 220 V Instructions for use MN 111 W H Med ENG Rev11 ...
Page 2: ......
Page 103: ......
