115 volt wiring instructions (low voltage)
The 115 volt switch is for 115 volt applications only!
1)
Follow the instructions on the previous page
through step 2f.
Then proceed with the
following instructions.
a)
Connect the incoming
white
cord wire to the
blue #1, orange #3, and red #8
wires in
the motor connection box.
b)
Connect the incoming
black
cord wire to the
yellow #4
wire in the motor connection box.
c)
The motor connection box wires;
white #2, brown J and black #5
are joined to
themselves with a yellow wire nut.
d)
Double check
your connections and replace the cover. Install your power plug.
Installation Instructions for GS1
TOOLS NEEDED
•
A 3/8” drive socket ratchet handle with a 7/16” socket.
APPROXIMATE ASSEMBLY TIME
20 MINUTES
CAUTION!!!
Unplug your machine before assembling this guide system.
The flex guide and the fence positions may be interchanged from one side to the other depending
on your need at the time. Generally you would want the flex guide on the highest side of the
molding to protect it from being cut into by the long side of the knife. This will preserve your
flex guide, giving you the best flex and smoothest surface for running your stock.
Mount the flex guide, fence and sub plate to bed
extensions with the 1 ½” carriage bolts, flat washers,
and guide locking handles. The rounded edges of the
extended beds should be facing each other. The side
mounting flanges should be facing down
.
The metal bed extensions, seen in the picture,
are set 4 ½” from the sub plate.
The 1” long carriage bolts in your hardware bag are
for mounting the guide and fence directly on the bed
extensions and machine bed.
12
