5
INSTALLATION
Your radar head was designed for ease of use and installation and normally there is no need to perform
any kind of configuration. There are two ¼ inch mounting bolts to facilitate mounting to a bracket or
some other suitable structure. Both mounting bolts should be used since this will make the unit
impossible to rotate. The unit should be secure as possible so that it cannot vibrate. The unit is pointed
with the lid of the unit away from traffic. The unit must be pointed straight down the road. If the unit is
at more than a ten degree angle to the traffic it will start measuring a lesser speed than the actual speed.
See the following figure.
Towards Traffic
The unit has a configurable dip switch. In most cases it will not be necessary to change it, but in rare
instances it could be necessary. Remove the lid of the unit to expose the underlying circuit board that
contains the dip switch. See the following figure.
KPH
MPH
RUN
DIAG
232
485
ENA
DIS
