23
Open the door by raising the handle. If the equipment is hot, you can use insulated
gloves. Adjust the primary air regulator and
secondary air regulator
to the Table 1. Put
coal lighter or wood wool into the fire grate, followed by wood chips. First insert small
pieces of wood, and then larger ones, light them and close the door again. When the
wood burns quickly, and leaves sufficient glowing embers, put additional fuel on the
fire. Thereafter, adjust the primary air regulator and
secondary air regulator
according
to the Table 1 („Adjustment of the burning air”). The first kindling should be performed
“finely” with little fuel only, so that the parts of the fireplace be adapted to heat. During
the first kindling, the generation of smell is normal.
1.3 Putting out of operation
Let the glowing ember burn to ashes and the fire-place get cold.
Empty the furnace chamber.
Close the doors and push the primary air regulator totally closed.
1.4 Heating instructions
The fireplace should be operated only with closed furnace chamber door. Fireplaces
belonging to type 1 have self-locking furnace chamber doors. These doors may be
opened only for kindling, loading or when cleaning the furnace chamber (otherwise
draught problems may occur with other equipment connected to the same chimney).
Warning!
When opening the furnace chamber door, any incorrect handling or insufficient
draught may induce smoke. Always ensure that the furnace chamber door may
be opened only slowly, first just to a small extent, and then fully after a few sec-
onds. In addition, if you intend to put additional fuel into the fire, before the
opening of the door only there may be only ember bed in the burning space, i.e.
no flames may be visible.
Led into the burning space in correspondence with the existing conditions, the secon-
dary air provides for the follow-up burning of the combustible components of in the
burning space. This in fact means smoke and soot-poor burning, which contributes to
the protection of the environment. If you wish to commission the fireplace in a transi-
tional period, please, please first examine the chimney draught, as it can be especially
weak at high external temperatures. Towards this end, hold a burning match in the
slightly opened feeding door. If the flame is not drawn significantly by the draught,
then a so-called starting fire is to be set first. Towards this end, burn wood chips/wool
in the fireplace or the cleaning hole of the chimney. Please, be careful not to dispose
glowing materials into the waste bin.
Warning!
In order to keep the air clean and safeguard the fireplace, do not ex-
ceed the specified maximum fuel quantity, otherwise overheating may occur,
which potentially damage the equipment. Such damage is not covered with any
guarantee. Only a single layer of fuel is allowable to be prepared in the fireplace.
Try to reach lower heating performance only by decreasing the quantity of fuel,
and not by cutting the primary air supply.
