DECALING
1. After cutting out the decal, dip in water
for 10 seconds, remove and let stand for 1
minute. Slide decal onto surface, position
and then blot off any excess water.
2. Lightly brush Micro Sol® on top. This will
soften the decal allowing it to conform to
irregular surfaces. DO NOT TOUCH
DECAL while w
et!
3. When the decal is thoroughly dry, check
for any trapped air bubbles. Prick them with
the point of a small pin or hobby knife
blade and apply more Micro Sol®.
A. Glue the walls (2, 4, 6) to the base (1). Then, place (do not
glue) the horizontal bracing (11) on the base. Now, glue the
vertical bracing (7, 8) in place on the base, making sure that
they go in front of the crosswise braces of part #11. The end
most vertical posts rest on top of the "lip" on the base and the
remaining upright posts go into the square holes so that they
are even with the bottom of the base. Next, slide part #11 up
and glue the bottom of the first crosswise brace on parts #Ss
7 and 8 and on top of the tabs on the back wall. Glue the
ladders (1 0) and railing (12) in place. Glue the windows (20)
and window "glass" (21) in place on clerestory wall (17) and
glue this to the top and back of part #8. Repeat for second
shed.
7
8
11
6
4
2
1
21 x4
20 x4
17
14
17
10
10
12
15
5
9 x8
3
B. Now, glue the clerestory end walls (16) to both the ends of
both sheds thereby, joining them into one. Then, glue the clere-
story braces (18) in place, one against each end and the others
in the middle, using the notches
and vertical ribs on part #8 to
locate. Glue the roof pieces (14, 19)
onto their respective places to
finish.
14
16
18 x10
16
19
DOUBLE SHED
