DECALING
1. After cutting out the decal, dip in water for 10 seconds, remove and
let stand for 1 minute. Slide decal onto surface, position and then blot
off any excess water.
2. Lightly brush Micro Sol ®on top. This will soften the decal allowing
it to conform to irregular surfaces. DO NOT TOUCH DECAL while
wet!
3. When the decal is thoroughly dry, check for any trapped air bubbles.
Prick them with the point of a small pin or hobby knife blade and apply
more Micro Sol ®.
6. Glue the roof (26) panels on. Then glue the clerestory (27, 28, 29)
together and to the top of the roof. Note: The ridges at the top of the
roof will fit into the bottom gaps on the inside of parts #27.
7. Glue the vent (30, 31, 36) together and then on the roof at a loca-
tion of your choice.
