Waltco Lift BZ-33, Installation Manual

Page: 39 / 66

Chapter 4 Liftgate Installation
ELECTRONIC AUTOMATIC TILT
For units equipped with Auto-tilt, install the angle
sensor. The angle sensor should be positioned on the
lift arm as shown.
Note:
When installing on the left arm, the sensor’s cable input
must be facing upwards.
When installing on the right arm, the sensor’s cable
must be facing downward.
GR03023
CONSTRUCTION OF TILT CYLINDER
1. Screw
2. Adjustable collar
3. Washer
4. Lock screw (x3)
5. Ring
6. Ring’s Lock Screw
GR02803
ADJUSTING TILT UP ANGLE
Note : Do not adjust the tilt cylinders before they are
installed onto the platform. Tilt cylinders are pre-
adjusted at the factory.
Position and install cylinder as shown:
GR02813
Note: Make sure
the grease zerk
Is facing upwards
Ring’s Lock Screw
page 39