"
Easy
"
Jump Starter
This product has been carefully designed to give you peace of mind while on the road.
Please read this manual thoroughly before operating your new product, as it contains
the information you need to become familiar with the product‘s features and obtain the
performance that you need during a roadside incident. Please keep this manual on file for
future reference.
Fuse replacement
About Your Easy-Start Battery Charger
The Easy-Start Battery Charger is designed to be used when your automobile will not
start due to a dead or low charged battery. Used properly, it can quickly get your vehicle
running so you can safely reach your destination.
If necessary, replace with same fuse type and rating only.
Location of Controls
12-Volt Plug (Dead Battery)
12-Volt Plug (Good Battery)
Test/Charge Switch
Warnings
• Keep out of the reach of children.
• This product has been designed for emergency use ONLY. Do not use in any other
manner than described. Do not use for other than intended purposes. Doing so may
result in serious injury or property damage.
• Be certain the input to your car is 12-volts. Do not use a 24-volt power supply, as
this can cause harm to your vehicle‘s electrical system.
• Be sure to use 12-volt power outlets only, not cigarette lighter outlets.
• Do not attempt to push start your vehicle. This could damage the engine.
• Avoid contact with any battery acid. It is corrosive to skin and clothing.
• Do not disconnect the battery of the disabled vehicle. This could damage the
electrical system.
• Be certain vehicles ARE NOT TOUCHING. Also, be certain that you are not
touching both vehicles at the same time while charging. Electricity can and will travel
through a person‘s body.
Operation
• Turn your Easy-Start Battery Charger to the „Test“ position, and insert the plug into
the dead car‘s 12-volt power outlets only, not cigarette lighter outlets.
• Insert the other plug into the 12-volt power outlets only, not cigarette lighter outlets,
of the car with the good battery.
• In the car with the dead battery, turn the ignition key to the „Off‘ position. The test
light should turn green and the charge light will turn red to indicate a good, solid
connection between both vehicles.
• Turn the Easy-Start Battery Charger switch to the „Charge“ position.
• Start the vehicle with the good battery and leave it running until it charges the dead
battery. See the chart below for charging times.
• Once the car with the dead battery is properly charged, do not shut off the vehicle
until you reach your destination; have the battery checked for proper voltage as
soon as possible.
Safety Features
• Short-circuit protection. Automatically shuts off.
• Thermal protection. Automatically turns unit off if it overheats.
Specifications
Input: 12V DC, 12.5A
Output: 12-Volt DC, 12.5A/ 150W max
Fuse: 15A Tube-type
EN
This product has been carefully designed to give you peace of mind while on the road.
Please read this manual thoroughly before operating your new product, as it contains
the information you need to become familiar with the product’s features and obtain the
performance that you need during a roadside incident. Please keep this manual on file
for future reference.
XXXXXX
.
Charge Time Guidelines
Times / Minutes
Engine Trouble
5
Engine turns slowly when starting
10
Engine makes clicking sound when
starting
15
Engine does not turn or make any sounds
20
Headlights do not turn on
