WX540, WX540L
Trailer Wood Splitter
Operating Instructions
29
00644
Fig. 25 –
Hydraulic Control Valve Positions
IMPORTANT! Do not hold the valve lever to extend or
retract the cylinder once it has reached the end of its stroke.
Doing so can overheat the oil and could damage the engine.
5.
If the log is large enough to require another split, reposition
and repeat steps.
00706
Fig. 26 –
Single Blade Wedge
6.
Pile the split wood close to the working area, but do not
allow pieces to pile up and clutter the area. A cluttered
working area can lead to tripping and an accident.
6.13 Vertical Splitting
1.
Before tilting the splitter frame, lower the rear jack stand.
Loosen the handle counter-clockwise, lower the stabilizer
and tighten the turn handle.
00651
Fig. 27 –
Rear Jack Stand
2.
While standing beside the controls, release the splitter
beam by pulling the spring-loaded frame latch outward.
3.
At the same time, grab the cylinder end and tip the splitter
beam assembly up towards the vertical position.
00623
1
2
Fig. 28 –
Rotate Splitter to Vertical
4.
Continue tipping, while placing your foot on the hydraulic
tank / axle as a brace, until splitter is in the full vertical
position.
5.
Set the log or block onto the splitter base.
Summary of Contents for WX540
Page 44: ......
Page 45: ...www wallensteinequipment com ...
