WX540, WX540L
Trailer Wood Splitter
Operating Instructions
25
6.5 Engine Oil Level Check
Check engine oil level daily.
Check with the machine parked on level ground and the engine
stopped.
IMPORTANT! Running the engine with a low oil level can
cause engine damage that is not covered by warranty.
1.
Remove the oil level dipstick and wipe it clean.
2.
Fully insert the oil level dipstick, then remove it to check the
oil level.
The proper level is when the oil is visible at the
full (upper) mark on the dipstick.
3.
If the oil level is low, add oil until the level is at the full mark.
SAE 10W-30 is recommended for general use.
4.
Reinstall the oil level dipstick.
00197
2
1
Fig. 15 –
Engine Oil Level check
1. Oil Level Dipstick
2. Oil Filler
Refer to the engine owner's manual included in the manual
tube for further information on engine oils
.
6.6 Hydraulic Oil Level Check
Check hydraulic oil level every 40 hours or weekly.
Check with the machine parked on level ground and the engine
stopped.
The proper level is when the oil is visible at the full (upper)
mark on the dipstick.
00638
Fig. 16 –
Hydraulic Tank Oil Level Dipstick
IMPORTANT! Do not operate machine if oil level is not
visible on the dipstick. Damage to the pump and other
components can occur.
Do not overfill the tank past the full mark.
Always check oil levels after changing filters or servicing
hydraulic components.
Hydraulic oil quality should be inspected every 40 hours. If
the oil is dirty or smells burnt, it should be replaced.
Be aware of high oil temperatures. Temperatures higher
than 180 °F (82 °C) could cause seal damage and degrade
oil quality.
6.6.1 Hydraulic Oil – Adding
The hydraulic system uses
Dexron® III ATF
.
1.
Clean the area around filler cap and remove it.
2.
Use a clean funnel and add oil until the level is at the full
mark on the dipstick.
3.
Install filler cap securely. Wipe up any spilled oil.
Summary of Contents for WX540
Page 44: ......
Page 45: ...www wallensteinequipment com ...
