Storing the Wood Splitter
WX370
3-point Hitch Wood Splitter
26
6.7.2 Prepare for Transport
•
Make sure the pivoting main frame is fully lowered
to horizontal. The lock pin in the pivoting splitter
beam must be fully engaged.
•
Swing the locking latch up to engage the tab on the
splitter frame. Insert the lynch pin.
00750
Fig. 18 –
Lock Pin and Latch Engaged
•
Clean all debris from the splitter that could fall off in
transport.
•
Always be in compliance with all applicable local
regulations when transporting.
7. Storing the Wood Splitter
After the season's use and the wood splitter is going
to be put away in storage, it should be thoroughly
inspected and prepared. Repair or replace any worn
or damaged components to prevent any unnecessary
down time at the start of next season.
The wood splitter can have a long, trouble-free life by
following these steps:
1.
Place the splitter in the horizontal configuration.
Fully retract the cylinder ram.
2.
Thoroughly wash the machine using a pressure
washer to remove all dirt, mud, debris, and
residue.
3.
Inspect the wedge, cylinder ram, anvil and wear
plates for damage or entangled material. Repair
or replace damaged parts. Remove all entangled
material.
4.
Touch up all paint nicks and scratches to prevent
rusting.
5.
Store the machine in an area away from human
activity. Select an area that is dry, level and free
of debris to park the wood splitter. Set it down on
wood blocking.
6.
If the wood splitter is not stored inside a building,
cover with a waterproof tarp. Tie securely in place.
7.
Do not allow children to play on or around the
stored machine.
7.1 Removing from Storage
1.
Review and follow the Pre-operation Checklist.
See
2.
Review safety and operation procedures. See
