WX370
3-point Hitch Wood Splitter
Operating Instructions
23
6.4.1 Pre-operation Checklist
Efficient and safe operation of the Wallenstein
wood splitter requires that each operator reads and
understands the operating procedures and all related
safety precautions outlined in this section.
A Pre-operation Checklist is provided for the operator.
The checklist is important for both personal safety and
keeping the wood splitter in good mechanical condition.
Before operating the machine and each time thereafter,
check the following:
Pre-operation Checklist
Wood splitter is mounted on a tractor less
than 100 horsepower.
Extra weights are mounted on the front of the
tractor, if required.
Wood splitter is properly attached to the
tractor. Lynch pin retainers are installed in
mounting pins.
Check the wedge and anvil. Be sure they are
not damaged or broken or badly worn. Repair
or replace as required.
Check and remove any entangled material.
Check for hydraulic leaks. Tighten
connections or replace components to stop
leaks.
Check and tighten all fasteners. Make sure
the equipment is in good condition.
Check that appropriate equipment for
personal protection is being used and in good
condition.
Check that jewelry, loose-fitting clothing are
not worn. Make sure long hair is tied back.
6.5 Splitting Logs
IMPORTANT! Park the wood splitter on a level,
dry work area free of debris and other objects.
Position the splitter so the prevailing wind blows
engine exhaust away from the operator.
1.
Make sure working area is clear of stones,
branches or other obstacles.
2.
Precut logs to desired block size, ready to load
onto splitter bed.
3.
Determine where the split wood is going to be
piled. Make sure that location does not interfere
loading splitter.
4.
Move tractor into its working position, set the
3-point hitch and the splitter to a comfortable work
height. Set the park brake.
5.
Set the throttle in its mid-range position. Place the
working hydraulic circuit in detent.
6.5.1 Log Placement
WARNING!
Risk of pinching or crushing hazard between the
wedge or push block and the log!
Never place hands at the ends of the log.
Always grasp logs by the sides when loading or
removing.
W035
• Always grasp the log by the sides not the
ends when placing in or removing logs from
the splitter.
This minimizes the chance of getting
fingers, hands or an arm between the wedge and
the log.
WARNING!
Risk of pinching or crushing hazard! The worker
loading the splitter MUST be the only one in
control of the hydraulic cylinder and splitting
wedge.
Only one worker should operate and load the
wood splitter.
W036
6.5.2 Horizontal Splitting
1.
Place wood or log on the splitter.
2.
Push control lever forward and hold to split wood.
