Installation
QC620
Skid Digger
20
5.3 Remove from a Skid Steer
WARNING!
Risk of serious injury from escaping high-
pressure oil. Actuate controls after engine
shut down to relieve trapped pressure before
loosening hydraulic connections.
W080
1.
Select an area that is dry, level, and free of debris, away
from human activity.
2.
Retract the bucket and lower the skid digger to the ground.
If the ground is soft or wet, set it on wood planks or a
pallet.
3.
Turn off the skid steer engine. Move the bucket-tilt control
lever several times to relieve any trapped pressure in the
circuit.
4.
Place planks or blocks under the bucket, boom, and base.
Make sure the skid digger is stable.
5.
Disconnect the hydraulic hoses and cap the lines to prevent
dirt from getting into the couplers.
6.
Tilt the skid steer hitch forward to disengage the flange on
the mounting plate.
7.
Push the latch arms fully up to retract the latch pins from
the mounting plate latch-pin mount and release the skid
digger.
8.
Move the skid steer away from the skid digger.
If you are storing the skid digger for an extended length of time,
see
.
