Wallenstein FX Series, Manual, Page: 5 / 11

FX Series
tele Radio® Transmitter & Receiver
5
Remote Winch Control
NOTE: With the UP button released (clutch
disengaged), the winch drum can free
wheel so cable can be pulled out.
5. Automatic Shutdown
The transmitter shuts down automatically after three
minutes of inactivity.
6. Synchronizing Transmitter and
Receiver
In the event it is necessary to synchronize a new
transmitter and receiver, use the following steps:
1. Remove the cover from the receiver.
2. On the circuit board, press the small receiver
Function (F) button. The function LED lights red.
F
S
F
S
00835
Fig. 5 – Receiver Function and Select Buttons
3. Press the receiver Select (S) button just below the
Function Button. The relay LEDs light red.
4. On the transmitter, press and hold the up and
down arrows simultaneously. The LEDs inside the
receiver then flash three times to acknowledge the
signal is being received.
5. Release the buttons on the transmitter. The relay
LEDs flash red once indicating receiver and
transmitter are now synchronized. If no transmitter
is found within approximately 10 seconds, the
receiver exits to normal operation.
7. Erasing all Transmitters from the
Receiver
In the event it is necessary to erase a transmitter from
the receiver, follow these steps:
1. Press the receiver Function (F) button. The
function LED lights red.
2.
Press the receiver Select (S) button. Keep pressed
at least 4 seconds. All relay LEDs light red then go
off.
3. Release the receiver Select (S) button. All
transmitters are now erased from the receiver.
If the function LED flashes red, one or more
transmitters are still registered in the receiver and the
above procedure needs to be repeated.