Wallenstein CT16B, Operator'S Manual

Page: 28 / 48

6.4 Reduction Case Oil Level Check
Check reduction case oil at each use. Check with the machine
parked on level ground and the engine stopped.
1
2
3
01816
Fig. 31 –
Reduction Case
1. Oil Level Check Bolt
2. Oil Level
3. Filler Bolt
1. Remove the Oil Level Check Bolt (1) and washer. The oil
level should be visible at the edge of the bolt hole.
2. If the level is below the check hole edge, remove the Filler
Bolt (2) and washer. The reduction case uses the same oil
as the engine. Add oil until it starts to flow out the check
hole.
3. Install the oil level check bolt, filler bolt, and washers.
IMPORTANT! Operating the engine with a low reduction
case oil level can cause reduction case damage.
Pre-start Checks
CT16B / CT24B
Trailer Firewood Conveyor
28