26
4�7�6 MOVING
The BXMC34SEU and the BXMC34BEU are
designed to be moved easily by tilting the
chipper back on its wheels using the hand-holds
in the shredder intake chute.
Tilt the unit back, then pull the unit to the desired
location. Ensure the engine is off and the clutch
lock is engaged before moving.
On the BXMC34SEU model, the wood mulch
is directed into the discharge cage under the
motor, and the unit must be moved periodically
to prevent plugging as the chips build up.
The BXMC34BEU uses a mulch collector bag
and does not require periodic moving.
Attaching \
Removing
Collector
Bag
Strap
Zipper Bottom
4�7�7 COLLECTOR BAG
(optional)
The BXMC34BEU model is designed with a
discharge chute that can be used with the optional
mulch collector bag (#Z99006). The mulch
bag holds 2.7 cu.ft (28 litres) and is a mildew
resistant synthetic material. It is a porous material,
allowing air from the rotor to pass through without
restricting collection of the mulch.
•
Lift the spring loaded deflector, and slip the
collector bag over the end of the discharge
chute.
•
Use the strap on the end of the bag to attach
and secure it to the chute.
•
When full, loosen the strap, remove the bag from
the chute and take it to the mulch area.
•
Unzip the bottom of the bag and spread the
chips and mulch over the desired area.
•
Zip up the end of the bag and re-attach it to the
discharge cute.
No Bag:
The BXMC34BEU model can be used with
or without its collector bag. Be sure that the
deflector is down, so that the mulch will be
directed to the ground. Position the chipper
at the work site to allow room for the mulched
material to be accessible
Hand Holds
BXMC34SEU
Discharge Cage
Deflector
BXMC34BEU
Discharge Chute