Wallenstein BX102S, Operator'S Manual

Page: 33 / 44

BXS Series
3PH Self-feed Chipper
Service and Maintenance
33
8.2 Maintenance Schedule
Perform maintenance procedures at time shown or hour interval,
whichever comes first.
As required
Remove entangled material from chipper.
Lubricate hinges and pivot points.
Every 8 hours or daily
Grease PTO Shaft
See this page, and page
35
Perform Pre-operation check See page 27
Every 50 hours or annually
Check rotor blade sharpness See page 36
Check ledger knife sharpness See page 7
Check twig breaker See page 35
Grease entire machine See page 34
Every 100 hours or annually
Wash and clean wood chipper. Remove entangled material, wood
chips, small debris.
8.3 Grease Points
IMPORTANT! Use a hand-held grease gun for all greasing.
Pump one shot of grease per fitting.
• Wipe grease fitting with a clean cloth before greasing to
avoid injecting dirt and grit.
• If fittings do not take grease, remove and clean them
thoroughly. Replace grease fittings as necessary.
Location Every 8 hours of operation
1 PTO Shaft Universal Joints
2 PTO Shaft Slip Joint
01367
1
1
2
Fig. 36 –
8-hour Grease Points